extra fine midge mesh

3. The structure of the dog cage should be reasonable

There is no adhesion test of powder spraying or fluorocarbon spraying on packaged galvanized wire, but there are two points for reference: first, in sealed or air-free environment, non-metallic volatiles can corrode zinc coating; Second, zinc at higher than 230 degrees (c) will cause the matrix metal brittle. And powder spraying and fluorocarbon spraying are to be baked at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in coating adhesion decline, and even lead to (matrix) steel wire brittle situation may exist.

Appellation: Hook fence net is a variety of fence net. The diameter of the opposite side of each mesh is generally 6.5cm-14cm. The diameter of the wire used is generally from 3.5mm to 6mm. Wire material is generally Q235 low carbon wire. The iron wire is welded into black pieces of decorative hook mesh by ginning. The overall size of the mesh is 1.5 m X4 m, 2 m X4 m, 2 m X3 m. The general surface treatment is cold (electric) galvanized treatment. There are also hot dip galvanizing, dipping, spray. But overall, 99 percent is cold (electric) galvanized.

Dogs of all ages seem to love to touch their noses with humans and other animals. In fact, dogs touch their noses as a way of socializing, just like humans shake hands and hug when they meet. But dogs don’t touch every human or every animal. They pick and choose who to touch. If they don’t like you or don’t know you at all, they won’t touch your nose. However, adult dogs will touch almost every puppy’s nose, and they will not only touch the puppy’s nose, but also smell it.

Good galvanized wire, plating thickness of 3- 4 mm, zinc adhesion should be less than 460 grams/m, that is, the average thickness of zinc layer is not less than 65 microns. When the thickness of plated parts is greater than 4 mm, the zinc adhesion should not be less than 610 g/m, that is, the average thickness of zinc layer should not be less than 86 microns. Standard galvanized wire coating must be uniform, galvanized layer basically uniform with copper sulfate solution test etching five times no dew iron. For standard galvanized wire coating adhesion requirements, the zinc layer of plated parts should be firmly combined with the basic metal and have enough adhesion strength, after hammer test does not fall off, not convex.