replacing fly screen mesh

The most obvious gap in a short time is the cross section. Because the hot-dip galvanized barbed rope is surface anticorrosive treatment, there will be rust in the cross section, while the stainless steel barbed rope because the internal raw materials are consistent with the surface raw materials, so there is no such situation.

The life of the “wire”, is actually “low carbon steel wire”, carbon content in less than 0.2%. The surface is usually coated with zinc plating because it is easy to rust. Under atmospheric conditions, the galvanized layer will not rust before most of the fall off, relatively soft. The life of the “steel wire”, is carbon content in about 0.6% of the “carbon steel wire”, or carbon content in about 0.8% of the “high carbon steel wire”, they have enough hardness and elasticity after appropriate heat treatment, high strength. Uses such as winding ordinary spring and so on.

Reverse twisting of the barbed rope: first wrap the barbed wire around the main wire (that is, a single piece of iron wire) and then add an iron wire and twist together to form a double strand of barbed rope.

Steel wire and iron wire have a lot of similarities, but carefully distinguish, you will find that they are not only different in the material, but also in the product characteristics are very different. So when choosing, make sure you make a clear distinction between the two. Steel wire factory introduces steel wire carbon structure steel made above, generally not galvanized, used for machinery, spring. Black and hard; Iron wire: low carbon steel (mild steel), galvanized, used for joining and wrapping. It’s white and soft.

Since nose touching is an important part of a dog’s social behavior, humans can use this to train them. Experts say that if owners touch their dogs’ noses regularly when they are young, they will have softer personalities and be less likely to hurt when they grow up.

Strength of galvanized wire: tensile strength is the great tensile stress that the material can withstand before tensile fracture; Yield strength has two indexes: upper yield and lower yield. It is a process in which the stress does not increase but the deformation continues to occur during the tensile process. When the force value drops for the first time, the major stress is the yield strength, and the yield strength must be less than the tensile strength.