No matter how big they are, dogs seem to love touching noses with people and other animals. In fact, nose touching is a form of social interaction for dogs, much like shaking hands and hugging humans. But dogs don’t rub their noses with every person or animal. They choose who to rub their noses with. If they don’t like you or don’t know you at all, they won’t touch your nose. However, adult dogs will touch the nose of almost every puppy. They will not only touch the puppy’s nose, but also smell the puppy.

Hot dip galvanizing is also called hot dip zinc and hot dip galvanizing: it is an effective way of metal anticorrosion, mainly used in various industries of metal structure facilities. It is to immerse the steel parts after rust removal into zinc solution melted at about 500℃, so that the surface of the steel members is attached with zinc layer, so as to play the purpose of anticorrosion.

The spring steel wire is made of high carbon and high quality carbon structural steel or carbon tool steel wire rod, and its chemical composition, gas content and non-metallic inclusion must be strictly controlled according to the use of the spring. In order to reduce the appearance of shortcomings and decarbonization layer, the consumption of rod billet to stop surface grinding, if necessary, but also stop peeling.

Cold galvanizing is also called electric galvanizing. It is the use of electrolytic equipment to remove oil, pickling, and then put the pipe into the solution of zinc salt, and connect the anode of the electrolytic equipment, place zinc plate on the opposite side of the pipe, and connect the positive pole of the electrolytic equipment to the power supply. A layer of zinc is deposited on the pipe fitting by directional movement of an electric current from the positive pole to the negative pole. Cold plated pipe fitting is processed before galvanizing.

Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four sides of the asbestos block are used up, maintenance workers will continue to use the block after repair when necessary to reduce the consumption of asbestos block.

HPMC gel is used in pesticide product formulations to enhance the adhesion of active ingredients to plant surfaces and improve the efficacy of pesticides.

Sunscreen products:

Answer: hot water solution method: because HPMC is not dissolved in hot water, so the initial HPMC can be evenly dispersed in hot water, then quickly dissolved when cooling, two typical methods are described as follows:
1) Put the required amount of hot water in the container and heat it to about 70℃. Under the slow stirring gradually add hydroxypropyl methyl cellulose, HPMC began to float on the surface of the water, and then gradually form a slurry, the slurry cooling under the stirring.
2) Add 1/3 or 2/3 of the required amount of water into the container, and heat to 70℃, according to the method of 1), disperse HPMC, prepare hot water slurry; Then add the remaining amount of cold water to the hot slurry, stirring and cooling the mixture.
Powder mixing method: HPMC powder and a large number of other powdery material ingredients, mixing fully with a blender, then add water to dissolve, HPMC at this time can dissolve, and do not stick together, because each small corner, only a little bit of HPMC powder, water will dissolve immediately. - Putty powder and mortar production enterprises are using this method. [Hydroxypropyl methyl cellulose (HPMC) is used as thickening agent and water retaining agent in putty mortar.]

3.2.1.1 Cellulose

3.1.1 Conditions of use