无关键词

无关键词

...

无关键词 无关键词

Read More
  • Stainless

    无关键词

    ...

    无关键词 无关键词

    Read More
  • barbed

    无关键词

    ...

    无关键词 无关键词

    Read More
  • 无关键词

    ...

    无关键词 无关键词

    Read More
  • During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

    无关键词

    ...

    无关键词 无关键词

    Read More
  • And high quality data is constrained by production cost and production conditions, so some welding mesh manufacturers do not meet this requirement, natural in this case, there is no way to improve the strength of the product. In addition to the data, there is the production process, even if it is the best data, but the manufacturer does not meet the production process requirements in the welding, it will also form the product under high pressure welding, so this is also a decline in strength, the process conditions of different manufacturers are also very different, so it forms the market above the product has a difference in strength.

    无关键词

    ...

    无关键词 无关键词

    Read More
  • Electric

    无关键词

    ...

    无关键词 无关键词

    Read More
  • 无关键词

    ...

    无关键词 无关键词

    Read More
  • 

    Popular articles

    Latest articles

    Links