1.5 x1 5 wire mesh
Latest articles
1.5 x1 5 wire meshLarge hexagonal mesh called stone cage net, is mainly used for mountain protection, hydraulic construction and so on. Small wire hexagonal mesh is used as a good material for breeding, will twist twist hexagonal mesh in the welded iron frame on the hexagonal mesh welding into chicken coop, pigeon cage, rabbit cage cage cage, hexagonal mesh is the best material for breeding with a net.
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More
1.5 x1 5 wire mesh
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More
1.5 x1 5 wire meshCompared with the traditional barbed and twisted barbed rope, the raw material cost is relatively high because of the relatively complex process.
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More1.5 x1 5 wire mesh
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More1.5 x1 5 wire mesh
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More
1.5 x1 5 wire mesh
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More1.5 x1 5 wire mesh
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More
1.5 x1 5 wire mesh
Post time: 02-03-23...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More
1.5 x1 5 wire meshModerate rates of foam formation may be harmless. The small homogeneous particles with large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles will cause explosion. Using activated carbon mat to remove the surface active substances, or through the filtration of foam is not very stable, this is an effective measure; Other measures should also be taken to minimize the introduction of surfactant.
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More1.5 x1 5 wire mesh
...
1.5 x1 5 wire mesh 【1.5 x1 5 wire mesh】
Read More
Popular articles
- 2, pasture installation of thorn rope spacing, if it is cattle or horses due to the larger size, the spacing can be appropriately relaxed. But if it’s a sheep, it’s a smaller animal and you have to make it a little bit narrower.
- According to the habit often according to the basic galvanized hardware before plating treatment method, as long as it does not contact with water can keep 5~7 years or so without rust, of course, if it is a salt water test, it will not be over 4 hours. Hot dip zinc is to use zinc tin solution to cover the hardware, and the rust prevention time is about five times that of traditional galvanizing. The general outdoor construction is to use hot dip zinc, and the salt water test can do about 36 hours.
- Packaging is also very important, cut wire to do a good job in the bundle with plastic film tightly packed, and then in the regular box, to fill the whole box is very full and sealed, it is best not to have a half box of conditions, if there is a half box to fill with foam and other things, so that in the transit cut wire will not receive a little damage.
Some raw materials in the production of unstable processing, the wire itself will exist burr, surface small pits and other local defects. Galvanized steel in galvanized, generally should pay attention to the galvanized layer protection time of galvanized wire, and the thickness of galvanized layer has a great relationship. Generally speaking, when the main gas is relatively dry and used indoors, the galvanized layer thickness of galvanized wires is only 6-12μm, and under relatively harsh conditions, the galvanized layer thickness of galvanized wires needs 20μm, and can be predicted to reach 50μm.
Latest articles
-
-
-
Galvanized iron wire is selected from excellent low carbon steel, through drawing forming, pickling rust removal, high temperature annealing, hot dip galvanized, cooling and other processes. Galvanized iron wire should pay attention to the following points in the use process:
-
-
The spray blade has strong adhesion and mechanical strength, and is widely used in the isolation and protection of the boundary of grassland and railway, as well as the protection of garden apartments, units and prisons. The following Haorong for you to introduce the characteristics of spray blade rope.
-
Links
- There are two kinds of electrochemical protection. One is to connect a piece of metal that is slightly more vivid than it. For example, ships and ships will be inlaid with zinc blocks. The second is to connect the negative terminal of the power supply, such as iron and steel river locks are often connected with the negative terminal of the power supply, through the negative terminal. Its methods include: metal cover film such as electroplating, organic coating such as paint, transformation layer such as orchid or black, new elements to change the metal structure.
- D, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.
1, no paint and maintenance, long new not old, exempt you from maintenance fatigue and trouble, the lowest comprehensive cost. Stainless steel wire mesh can be used as poultry cage, egg basket, channel fence, drain tank, porch guardrail, anti rat net, mechanical protective cover, livestock and plant fence, grid frame, etc.
Flexibility because the wire is different from other stainless steel raw materials, it is low density so in the flexibility of the appropriate excellent, it can be described according to people’s fantasy into all kinds of different shapes. Some large enterprises will buy hook flower net products, its reasons are no more than two, one is to prevent people outside the enterprise to walk around at will, the second is to advance the whole image of the enterprise. Therefore, under the premise that the protection requirements are not high, galvanized hook net can play a role in its use, the appearance of flexible hook net is settled to the use of address, from a distance and look at it like a work of art quite appreciate the meaning.
The cooling circulation system uses spray to cool the drawing die, and takes away a lot of heat generated by the drawing machine in high speed drawing in time to ensure the quality of the wire. Control drawing process parameters: drawing speed 10 ~ 12m/s; Winding tension 8 ~ 10N; Measuring length 30km; The mass fraction of lubricant is 3.5 ~ 4.5%; pH value of lubricant 7 ~ 8; Lubricant temperature 30 ~ 40℃.
- Some birds suffer from illness due to poor diet or other injuries, and need timely treatment so that the birds can recover.
- With a large pickpocket for the steel wire, into the zinc liquid before the surface of the zinc ash stirring; Use a small outlet for steel wire galvanized; Zinc pot steel wire outlet in 30 minutes, with the pickpocket back and forth, until the large, floating zinc residue into brown yellow, real zinc ash, zinc ash surface. The zinc ash taken out should be brown yellow real zinc ash, zinc surface, effectively reduce the zinc consumption. This is one of the biggest measures to reduce zinc consumption, and it is a real problem, which has not been solved for many years.
Post time: 26-05-23Hot dip galvanizing, also known as hot dip zinc and hot dip galvanizing, is an effective way of metal corrosion prevention, mainly used in various industries of metal structure facilities. It is to immerse the steel parts after rust removal into the molten zinc liquid at about 500℃, so that the surface of the steel member is attached with zinc layer, so as to play the purpose of anticorrosion.
If not packaged, then a car of blade thorn rope can not be loaded with many pieces, but also relatively occupied places and easy to be lost in the process of transportation. Each bundle of blade barbed rope is 50 bundles. After hydraulic compression, the volume is reduced and it is more convenient to load and unload. Forklift trucks can load and unload easily. In general, when exporting, the blade thorn rope will be packaged for sale, so that the volume occupied in the container is relatively small, which can be very easy to size and place will not take up much place.
The material of small hexagonal net is the same as that of other hexagonal net, which is generally made of low carbon steel wire, stainless steel wire and galvanized steel wire as raw materials by the hexagonal net machine.
Pet cage is generally made of high quality iron wire, low carbon steel wire, stainless steel wire welding, its characteristics are beautiful, light, folding, easy to store. Pet cage surface treatment is generally: cold galvanizing, hot galvanizing, spraying, dipping, chrome plating, nickel plating and other methods. Pet cage is mainly used for family breeding pets and protection.
Post time: 21-12-22
Post time: 27-12-226, the use of special formula and special UV absorbent, no fading, no yellowing, no peeling, no cracking, no foaming, no moth, the use cycle can be more than 30 years.
“Dry” hot dip galvanizing is also called “drying solvent method” hot dip galvanizing. Iron and steel work pieces through degreasing, pickling, cleaning, dipping aid solvent and drying, and then immersed in the molten zinc solution to galvanize. The co-solvent is usually hydrochloric acid, ammonium chloride, or ammonium chloride mixed with zinc chloride in aqueous solution.
- The surface of the galvanized wire deposition layer before galvanized to remove the surface film layer, surface inclusion and other defects to the local, can be found and treated by conventional technology. Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless.
Annealed wire is a soft iron wire made of low carbon steel cold drawing, heating, constant temperature, heat preservation and other processes. The composition of iron wire varies according to its use. It contains iron, cobalt, nickel, copper, carbon, zinc, and other elements. The hot metal billet rolled into 6.5mm thick steel bar is the wire rod, and then put it into the wire drawing device into a different diameter of the line, and gradually reduce the aperture of the wire tray, cooling, annealing, plating and other processing technology made of various specifications of iron wire.
2, hot plating wire plating after processing
- In addition to these reasons, we should also pay attention to the tooling and process must be stable, and regular testing should be done to ensure the uniformity of galvanized layer.
Unless the stainless steel blade barbed rope produced now is a specially customized model, it is generally produced with a tool length of 22mm, which is what we usually call bto-22 type. It is not necessarily such a specification from 11mm to 65mm there are specifications. Unless the customer insists on customizing the specified length, the barbed rope manufacturer produces the bto-22 stainless steel blade barbed rope.
Post time: 17-06-22
Post time: 16-02-23- (4) granary storage, circle corn net.
- Avoid hanging cages near heaters, as failure to dissipate heat can interfere with bird molting.
Removal of surface-active substances by activated carbon matting. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to minimize the amount of surfactant taken in. The introduction of organic matter can make the electroplating process speed drop sharply. Galvanized iron wire blackening can be effectively prevented, such as: the work site to keep dry, reduce and do not use chemicals, operators with clean gloves and so on. In addition, hot dipping zinc factory can be required, after dipping zinc must be passivation treatment, passivation treatment of zinc has a better anti-discoloration effect, can effectively prolong the discoloration time, the combination of the two, discoloration should be able to solve.
- 2. When there are channels, ponds, lakes and other natural barriers on the side of the road, there is no need to worry about people and animals entering and illegally occupying the road land.
- Combination of fence mesh and maintenance network restrictions: Residential fence net, garden villa, private swimming pool, courtyard lawn, city scene, municipal transportation, sports venues, airports and ports, offices and schools, military equipment, prison farms, industrial parks, tourist resorts, distribution centers, The specifications and parameters of the fence mesh are as follows: 800, 1000, 1200, 1400, 1600, 1800, 2000, 2200, 2400 (mm) : 2000, 2500, 3000 mesh spacing (mm).
- The small homogeneous particles with large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles will cause explosion. Coating with activated carbon to remove surfactant, or filtering to make the foam less stable, are effective measures. Other measures should also be taken to reduce the amount of surfactant brought in to Z. The speed of electroplating can be significantly reduced by the addition of organic matter. Although the chemical formulation is conducive to high deposition rate, but the organic matter with the coating thickness can not meet the requirements, so activated carbon can be used to treat the tank liquid.
- The composition of hot dip galvanizing layer is composed of hot dip galvanizing layer, which is composed of iron zinc alloy between iron matrix and surface pure zinc layer. The shape of the workpiece is formed by the iron zinc alloy layer in hot dip, so that the iron and pure zinc layer touch outstanding. When the iron workpiece is immersed in a molten zinc solution, the initial zinc and iron (body) are formed at the interface. This is a crystal made up of zinc atoms in the solid metal iron. When two metal atoms are fused together, the gravitational force between the atoms is very small.
- Post-plating treatment (passivation, hot melting, sealing and hydrogen removal, etc.) for the purpose of enhancing protective properties, decoration and other special purposes. After galvanized, chromate passivation or other conversion treatment is generally required to form the corresponding type of conversion film, which is one of the key processes to ensure the quality of post-plating.
- Both sides of the galvanized welding net exposed can not be more than 2mm, so as to be qualified. And in the welding mesh of each warp and weft wire cross place, must be welded very firm, and if you want to welding very firm, both sides must have some warp and weft wire out, and the length must be controlled within two millimeters. From the mesh distribution is not uniform, galvanized is not uniform, but also to see whether the welding mesh is qualified standards.
