perf sheet metal

Latest articles

perf sheet metal

...

perf sheet metal perf sheet metal

Read More
  • galvanizing

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • Third, 201 is high manganese content, the surface is very bright with dark bright, high manganese content is easy to rust. 304 contains more chromium, the surface is matte, no rust. Put the two together and you have a comparison. The most important thing is that the corrosion resistance is different. The corrosion resistance of 201 is very poor, so the price will be much cheaper. Because of the low nickel content of 201, the price is lower than 304, so the corrosion resistance is not as good as 304.

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More

  • Post time: 02-02-23

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • In the atmosphere containing carbon dioxide and hydrogen sulfide and Marine atmosphere is not corrosion resistant, in high temperature and high humidity air and contain organic acid atmosphere is small, galvanized layer is also easy to be corroded. In order to make large rolls of galvanized wire on the surface of the deposited layer to the local, remove the surface film layer, surface inclusions and other defects can be found and treated by conventional techniques. Excess foam is caused by soaps and surfactant saponable fats brought into the tank, and moderate rates of foam formation may be harmless.

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • Decorative hook mesh size width generally does not span 2 meters. Generally, the length does not span 4m. It is difficult for workers to span 2m, and it is not good for galvanizing and plating. It can reach 6 meters in length, but it won’t cross 6 meters. Generally across 4 meters after the price will be significantly higher.

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • There are three methods to detect the thickness of zinc layer of galvanized wire: weighing method, cross section microscopy method and magnetic method, among which the first two experiments will cause certain damage to galvanized wire, including the length of galvanized wire and the reduction of dosage. The general detection of galvanized wire galvanized layer is detected by magnetic method, which is also a more intuitive and convenient method. The standard of galvanized layer thickness is related to the wire diameter of galvanized wire. The larger the wire diameter of galvanized wire, the thicker the galvanized layer is. It is the thickness of galvanized layer and cast iron after centrifugal separation.

    perf sheet metal

    ...

    perf sheet metal perf sheet metal

    Read More
  • 

    Popular articles

    Latest articles

    Links