common nails factory

common nails factory

...

common nails factory common nails factory

Read More

  • Post time: 15-11-22

    common nails factory

    ...

    common nails factory common nails factory

    Read More

  • Post time: 16-05-22

    common nails factory

    ...

    common nails factory common nails factory

    Read More
  • common nails factory

    ...

    common nails factory common nails factory

    Read More
  • After proper heat treatment or cold drawing hardening, high carbon steel wire has high strength and hardness, high elastic limit and fatigue limit (especially notched fatigue limit), cutting function is acceptable, but welding function and cold plastic deformation ability is poor.

    common nails factory

    ...

    common nails factory common nails factory

    Read More
  • Electric welding net welding after galvanized is after the completion of the welding and then cold galvanized or hot galvanized; After the first galvanized welding is to change the wire welding mesh, welding can be seen after the completion of the welding spot; The two processes are different prices are also very different, the cost of the first plating after welding is low, the surface is smooth, and the cost of the first welding after plating is higher, not easy to rust.

    common nails factory

    ...

    common nails factory common nails factory

    Read More
  • The drawing process of the waste product has a great influence on the function of the product. The general selection of about 90% of the larger total surface reduction rate (see area reduction rate) and the smaller pass surface reduction rate (about 23%), to ensure the endurance of the product. On the high strength spring steel wire, pulling should be controlled each time the temperature of the steel wire outlet is lower than 150℃, to prevent the steel wire due to strain aging and change the crack, which is the main drawback of steel wire waste.

    common nails factory

    ...

    common nails factory common nails factory

    Read More
  • Copper sulfate point test is a simple way to quickly distinguish ordinary carbon steel and all types of stainless steel wire rope. The concentration of copper sulfate solution used is 5%-10%. Before the point test, the experimental area should be thoroughly removed from the oil or other impurities, and a small area should be polished by grinding machine or soft grinding cloth, and then the test liquid drops to the grinding place. Ordinary carbon steel or iron in a few seconds will form a layer of outer metal copper, and the surface of stainless steel does not produce copper precipitation or display copper color.

    common nails factory

    ...

    common nails factory common nails factory

    Read More
  • common nails factory

    ...

    common nails factory common nails factory

    Read More
  • 

    Popular articles

    Latest articles

    Links