Suitable for general engineering building wall, pouring concrete, multi-storey building, etc., in the structure of heat preservation and heat insulation system plays an important role, when the construction will be hot dip galvanized welded wire rack together wall of heat preservation and heat insulation board placement will be concrete pouring mold inside, outside the wall heat preservation and heat insulation board and one kind of live, after ripping into heat preservation and heat insulation board and wall body. The coating on the surface of the welding core is called the coating.

Hot dip galvanizing, also known as hot dip galvanizing, is a method of obtaining a metal covering layer by immersing a steel member into a molten zinc solution. With the rapid development of high-voltage power transmission, transportation and communication, the protection requirements for steel parts are becoming higher and higher, and the demand for hot-dip galvanizing is also increasing. Usually the thickness of electrogalvanized layer is 5 ~ 15μm, and the large roll galvanized wire layer is generally more than 35μm, or even up to 200μm. Hot dip galvanized coating ability is good, dense coating, no organic inclusions.

The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.

Once you’ve removed the dirt from your fence, use a stiff wire brush to get rid of any loose paint or rust spots. If that doesn’t do the trick, use some fine sandpaper to remove any remaining rust.
Make sure your fence is completely dry after this step; whether you want to leave it to air dry in the sun or thoroughly dry it with a towel.