12 gauge slotted angle iron

The insulation layer of large rolls of galvanized wire and rigid thermal insulation products can be bound with double strands of galvanized iron wire, and the binding interval shall not exceed 400mm. The pipe or corresponding equipment with nominal diameter equal to or greater than 600mm shall stop reinforcement after binding, and the enclosed galvanized steel wire must be winched. The iron or wood rod should be tightened, but the tightening level should be moderate, not too tight or too loose, and not damage the wire. The consumption of wire and steel wire is generally used in drawing process and galvanized disposal.

6, barbed rope protection network layout should be according to the road boundary terrain necessary renovation, flat section level set, slope section slope or step set.

The above is xiaobian for you to introduce the anticorrosion ability of the better barbed rope. You can choose the right barbed rope products according to your actual situation.

The corrosion resistance of hot dip galvanized is much higher than that of cold dip galvanized, also known as electric dip galvanized. Hot wire will not rust for several years, cold galvanized will rust within three months. The cold galvanizing process is used to protect the metal from corrosion, for which the coating of zing filler is used,which is applied to the protected surface by any of the coating methods and dried to form a zinc filler coating with a zinc content (up to 95%) in THE DRY coating.

The whole welding process of galvanized steel wire mesh does not need special technological methods, good weldability. However, in a few cases, the welding process will present difficulties: the converter steel produced by the old smelting method has high nitrogen content and high impurity content, resulting in high cold brittleness, added aging sensitivity, lower quality of welded joints, and poor weldability.