steel mesh for fire pit

steel mesh for fire pit

...

steel mesh for fire pit steel mesh for fire pit

Read More
  • Mainly suitable for flat welding.

    steel mesh for fire pit

    ...

    steel mesh for fire pit steel mesh for fire pit

    Read More
  • (1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.

    steel mesh for fire pit

    ...

    steel mesh for fire pit steel mesh for fire pit

    Read More
  • galvanized

    steel mesh for fire pit

    ...

    steel mesh for fire pit steel mesh for fire pit

    Read More
  • The strength of the hook mesh should be satisfied: when the vehicle is traveling at 80 kilometers per hour, the hook mesh will not fall into the river when it bumps against the rail at a 15 degree Angle. The shape and color of the hook mesh should be in harmony with the surrounding natural environment. The phenomenon planning of the important Bridges should be done well. When the bridge crosses important traffic lines, such as expressways, urban rail transit, expressways, railway trunk lines, etc., the hook mesh should add the protective mesh on the pavement of the bridge deck.

    steel mesh for fire pit

    ...

    steel mesh for fire pit steel mesh for fire pit

    Read More
  • A. When the thickness of the plating is 3-4 mm, the zinc adhesion should be less than 460g/m, that is, the average thickness of the zinc layer is not less than 65 microns.

    steel mesh for fire pit

    ...

    steel mesh for fire pit steel mesh for fire pit

    Read More
  • steel mesh for fire pit

    ...

    steel mesh for fire pit steel mesh for fire pit

    Read More
  • 

    Popular articles

    Latest articles

    Links