extra fine midge mesh

Out-of-line annealing means that the recrystallization annealing of hot or cold rolled steel plate is carried out in the bottom type annealing furnace or cover type annealing furnace before entering the hot plating wire line, so that there is no annealing process in the galvanized line. The steel plate must maintain a clean active surface of pure iron, free of oxides and other dirt, before hot dip galvanizing. In this method, the annealed surface oxide sheet is first removed by pickling method, and then coated with a layer of zinc chloride or a mixture of ammonium chloride and zinc chloride solvent for protection, so as to prevent the plate from being oxidized again.

The steel mesh improves shock resistance and crack resistance. The longitudinal and transverse steel bars of the welded steel mesh constitute a network structure. Therefore, the bond anchorage between the steel mesh and concrete is good, and the load distribution is uniform, which significantly improves the earthquake resistance and crack resistance of the reinforced concrete structure. According to the practice test, the cracks of welding net are reduced by more than 75% than that of manual binding net. Greatly reduce the unnecessary cost of the construction process, shorten the construction cycle, the use of steel wire mesh is simple and convenient, easy to transport.

1. The diameter of raw materials and the thickness of the diameter have a direct impact;

Wire mesh welding after galvanized is through the end of the welding and then the cold company to make wire mesh wire mesh steel mesh construction mesh floor heating mesh galvanized or hot galvanized. After the first galvanized welding is to change the wire mesh, after the end of welding can see the welding spot; The two processes are different prices are also very different, the cost of the first plating after welding is low, the appearance is smooth, and the cost of the first welding after plating is higher, not easy to rust.

Stainless steel barbed wire in the way of corrosion is not too, because the surface is not treated but rely on its own raw materials for corrosion resistance, so there will be no chemical reaction.