4 inch x 4 inch wire mesh

The shape of the cage has round, square, octagonal, hexagonal and other shapes. Because the circular space uses a large area, it is more suitable for the activities of birds, and it is not easy to get hurt, so it is popular with everyone. A cage is dear to a man who loves birds, for it is inhabited by his master’s birds. If well maintained, it can be maintained for many years. Let’s look at how to maintain the cage.

Avoid hanging cages near heaters, as failure to dissipate heat can interfere with bird molting.

5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.

4. Cooling: The galvanized steel wire needs to be cooled to reduce its temperature to room temperature.

Requirements of the shaft
Even more important than a correct interference fit of the Oil Seal is a perfectly smooth shaft in the region of the seal, particularly if shaft surface speed is high and the medium to be sealed is under a certain amount of excess pressure. The surface roughness of the shaft depends on the average profile depth Ra of the tool marks caused by the machining process. Oil Seals made of PTFE require, independent of the surface speed, a surface roughness of between 0,1 to 0,2 mm, because PTFE has less wear resistance than rubber seals. For normal circumstances, the shaft in the region of the seal must have a surface roughness of approximately:  To summarize, the surface of the shaft in the region of the seal should not have noticeable machining marks. For pivoting shafts and other difficult or critical sealing applications, it is recommended that Oil Seals with a helical groove hydrodynamic pattern, which has a pumping effect, be used. When grinding and polishing, an axial movement of the grindstone along the shaft must be avoided in order to prevent machine lay. 

Despite being a great substitute for more expensive high temperature resistant materials, polyacrylate has a problem of poor water compatibility and cold flexibility.

This is one of the frequent reasons for oil seal failure, and this is majorly because of the volatility of any of the elastomer’s constituents. These causative constituents may be part of the elastomer formulation, or gases that got entrapped in the elastomer during the molding process. The deceiving fact about this failure is that sometimes the oil seal won’t show any visual sign of out-gassing, however, sometimes when the out-gassing is extreme, they shrink.

② Spring code