double loop cable ties

Latest articles

double loop cable ties

...

double loop cable ties double loop cable ties

Read More
  • For key and important parts with tensile strength greater than 1034Mpa, the stress should be removed at 200±10℃ for more than 1 hour before plating, and for carburized or surface hardened parts, the stress should be removed at 140±10℃ for more than 5 hours. The cleaning agent used for cleaning shall have no effect on the binding force of the coating and no corrosion on the substrate. Acid activation Acid activation solution should be able to remove corrosion products and oxide film (skin) on the surface of parts without excessive corrosion on the matrix.

    double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More
  • Now a lot of hardware manufacturers are producing iron wire, and the iron wire is very easy to rust, if you need to use in outdoor or humid places, the general customer will require the use of galvanized iron wire equipment to give the wire a layer of zinc, the thickness can be determined according to user requirements. Galvanized iron wire equipment is specially used for iron plating. Generally speaking, the stability of zinc is much higher than that of iron, and it will not rust in the daily water vapor or wet place.

    double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More
  • double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More
  • double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More
  • double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More
  • The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.

    double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More

  • Post time: 27-03-23

    double loop cable ties

    ...

    double loop cable ties double loop cable ties

    Read More
  • 

    Popular articles

    Latest articles

    Links