simple quail cage design

Galvanizing can be done by zincate galvanizing or chloride galvanizing. Appropriate additives shall be used to obtain a coating that meets the requirements of this standard. Luminescence treatment should be carried out after luminescence plating. The parts that need to be dehydrogenated for passivation should be passivated after dehydrogenation. Before passivation, 1%H2SO4 or 1% hydrochloric acid should be applied to activate 5~15s. Passivation shall be treated with colored chromate unless otherwise specified in the design drawings.

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.