bird cage wire for sale

The cleaning agent used for cleaning has no effect on the adhesion of the coating and no corrosion on the base material. Acid activation Acid activation solution should be able to remove corrosion products and oxide film from the surface of parts without excessive corrosion of the matrix. Zinc plating may be zinc plated with zincate or chloride and appropriate additives shall be used to obtain a coating that meets the requirements of this standard. After light plating, light treatment is carried out. Passivated parts requiring hydrogen removal shall be passivated after hydrogen removal. Activation with 1% H2SO4 or 1% hydrochloric acid for 5 ~ 15s prior to passivation.

Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.

Bird cage placement and attention

In addition, the corrosion resistance of hot-dip galvanized wire will also be affected by other factors. For example, in different environments, especially in some special chemical environments, such as acidic or alkaline environments, the corrosion resistance of hot-dip galvanized wire may be affected to a certain extent. At this time, it may be necessary to use other materials that are more resistant to corrosion to replace the hot-dip galvanized wire.

Paint on the galvanized layer, the binding force between each other and the baking temperature of the paint has a great relationship, after galvanized coating alkyd paint, adhesion is no problem. Galvanized amino paint, paint adhesion is not good. Do two bottom two surface, adhesion is ok, if the two bottom two surface to two bottom three surface, that is, more paint, more baking once, again test adhesion is very poor, poor to the paint from the galvanized layer of pieces torn off.