weld mesh 50x50

weld mesh 50x50

...

weld mesh 50x50 weld mesh 50x50

Read More
  • weld mesh 50x50

    ...

    weld mesh 50x50 weld mesh 50x50

    Read More
  • Steel mesh jinsu appearance treatment: polyethylene thermoplastic powder coatings is also called polyethylene powder coating, is the high pressure polyethylene (LDPE) as the basic material, adding a variety of function additives, colors, its antiseptic powder coating manufacturing processes, jinsu coating layer has the function of chemical, shock, circuitous, acid, salt fog corrosion, decorate a function and has good appearance.

    weld mesh 50x50

    ...

    weld mesh 50x50 weld mesh 50x50

    Read More
  • There is also a scaly or boride film or oxide. To remove the photosynovium or oxide commonly used methods are: lead grease removal method, acoustic cleaning method, alkali washing or pickling electrolysis grease to oxide method, these methods in the use of gas or steam harmful to human body, pollution, not environmental protection.

    weld mesh 50x50

    ...

    weld mesh 50x50 weld mesh 50x50

    Read More
  •  

    weld mesh 50x50

    ...

    weld mesh 50x50 weld mesh 50x50

    Read More
  • In order to improve the corrosion resistance of steel pipe, the general steel pipe is galvanized. Galvanized steel pipe is divided into hot dip galvanized and electric galvanized. The layer of hot dip galvanized is thick, the cost of electric galvanized is low, and the surface is not very smooth. Used for steel blowing oxygen pipe, generally with small diameter welded steel pipe, specifications from 3/8-2 inches of eight. Made of 08, 10, 15, 20 or 195-Q235 steel strip, in order to prevent corrosion, some should be aluminized.

    weld mesh 50x50

    ...

    weld mesh 50x50 weld mesh 50x50

    Read More
  • The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.

    weld mesh 50x50

    ...

    weld mesh 50x50 weld mesh 50x50

    Read More
  • 

    Popular articles

    Latest articles

    Links