pro twist drywall screws

The hot plating wire uses zinc-free slag to add hot melt zinc and galvanize, which avoids the traditional heating process and radiates the surface 1653 of zinc liquid surface 4102 to the hot melt zinc, reducing the high temperature oxidation on the surface of zinc liquid. At the same time, the heating body is in contact with the zinc liquid, and the heat is directly transferred to the zinc liquid. The utilization rate of heat energy can reach more than 90%, which reduces the heat radiation of the zinc liquid surface.

1. Zinc pot operators must stick to their posts

Weigh each reel of wire of different specifications, not less than the reel weight required in the contract, and record the value. Contact detection. No contacts are generated for each reel of wire. If there are contacts, no more than three contacts are generated for each reel. Each contact should be smooth surface treatment, the wire can not be pulled off from the contact, in line with customer packaging requirements.

For single-layer wound non-rotating wire rope, it is necessary to strictly abide by the above principles, otherwise it is easy to cause permanent deformation of wire rope structure; In the case of multilayer winding, the rotation of the rope is determined by the orientation of the reel’s rope groove to lay the foundation for the next layer. The friction between the wire rope and the extrusion pressure of the multi-layer winding drum are large, and the disorderly rope phenomenon is easy to occur. Therefore, the wire rope with a diameter slightly smaller than the pitch of the rope groove and the diameter of the rope groove should be selected to add the touch area between the wire rope and the drum.