epoxy coated wire mesh

The corrosion resistance of hot dip galvanized is much higher than that of cold dip galvanized, also known as electric dip galvanized. Hot wire will not rust for several years, cold galvanized will rust within three months. The cold galvanizing process is used to protect the metal from corrosion, for which the coating of zing filler is used,which is applied to the protected surface by any of the coating methods and dried to form a zinc filler coating with a zinc content (up to 95%) in THE DRY coating.

The most obvious gap in a short time is the cross section of this piece, hot dip galvanized barbed wire because it is the surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.

1, galvanized wire mesh molding sheet must be packed with flat hard data, to avoid eternal deformation due to poor packaging. It IS VERY IMPORTANT THAT EACH PACKAGE AND ROLL OF RAW SHEET MATERIAL BE MARKED WITH PRODUCT NAME, STANDARD, QUANTITY, TRADEMARK, batch number, MANUFACTURER, DATE of production, STACKING SYMBOL, INSPECTOR CODE AND INSPECTION CERTIFICATE.

In use, it can be well used to control the degree of softness and hardness in the annealing process, mainly used for binding silk and binding wire in the construction industry. Its use is not limited to handicrafts, of course, in the construction industry is also widely used. In the early days, the lanterns were made with wire outside and proper candles were placed inside. People hung them in front of the door and it was very beautiful to go up at night.

2. Stainless steel 316 material should be used in coastal areas, which can resist corrosion of sea water.