yard link fence
Latest articles
yard link fence
...
yard link fence 【yard link fence】
Read Moreyard link fence
...
yard link fence 【yard link fence】
Read Moreyard link fence
...
yard link fence 【yard link fence】
Read Moreyard link fence
...
yard link fence 【yard link fence】
Read Moreyard link fence
...
yard link fence 【yard link fence】
Read Moreyard link fence
...
yard link fence 【yard link fence】
Read MoreOne is to do a good job of galvanized wire packaging, avoid bump, to ensure the integrity of the zinc layer;
yard link fence...
yard link fence 【yard link fence】
Read Moreyard link fence
...
yard link fence 【yard link fence】
Read More
yard link fenceCold wire drawing is mainly used in the production of hardened low carbon steel wire, with a diameter of 8 mm steel bar to play a fixed role in the development of the construction industry has played a role in promoting the development of the construction industry, widely used. The bonding and anchorage performance between cold wire drawing and concrete is good. When used in components, the phenomenon of cracking in the anchorage area of components and damage caused by steel wire slip is fundamentally eliminated, and the bearing capacity and anti-cracking capacity of the end of components are improved.
...
yard link fence 【yard link fence】
Read More2. When there are natural barriers such as canals, ponds and lakes on the side of the road, barbed rope protection nets shall not be set up in the section where there is no need to worry about people and livestock entering and illegally occupying the road land.
yard link fence...
yard link fence 【yard link fence】
Read More
Popular articles
- Now a lot of hardware manufacturers are producing iron wire, and the iron wire is very easy to rust, if you need to use in outdoor or humid places, the general customer will require the use of galvanized iron wire equipment to give the wire a layer of zinc, the thickness can be determined according to user requirements. Galvanized iron wire equipment is specially used for iron plating. Generally speaking, the stability of zinc is much higher than that of iron, and it will not rust in the daily water vapor or wet place.
- 2.7*2.25mm means that the two strands are 2.7mm silk, and the thorns are 2.25mm silk.
- For single-layer wound non-rotating wire rope, it is necessary to strictly abide by the above principles, otherwise it is easy to cause permanent deformation of wire rope structure; In the case of multilayer winding, the rotation of the rope is determined by the orientation of the reel’s rope groove to lay the foundation for the next layer. The friction between the wire rope and the extrusion pressure of the multi-layer winding drum are large, and the disorderly rope phenomenon is easy to occur. Therefore, the wire rope with a diameter slightly smaller than the pitch of the rope groove and the diameter of the rope groove should be selected to add the touch area between the wire rope and the drum.
The main difference between the two is the carbon content. The carbon content of iron is 2.11 percent or greater, while the carbon content of steel is 2.11 percent or less. The iron carbon alloy with carbon content above 2.11% is cast iron (pig iron), which is basically not malleable and cannot be drawn into wire. Secondly, the content of impurities is different. The content of harmful impurities such as sulfur and phosphorus in steel is smaller. Steel wire general color focus, iron wire color light point, white point.
Latest articles
-
Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.
-
-
-
-
The most obvious gap in a short time is the cross section. Because the hot-dip galvanized barbed rope is surface anticorrosive treatment, there will be rust in the cross section, while the stainless steel barbed rope because the internal raw materials are consistent with the surface raw materials, so there is no such situation.
-
Links
Thorn rope factory production per ton of product profit is not particularly high so in the sales price to wholesale, many users always think that thorn rope price has a lot of profit space so they are eager to lower the price, some manufacturers in order to sell out on the use of low price promise and then underweight behavior. Often the actual user spends less money with the lack of weight is almost the same, so the unit price is relatively high. Because the quotations of the thorn rope factory are in accordance with the real price, the quality is guaranteed. In this way, the customers will not look for debts after the purchase, and the subsequent purchase work will still find us, so that we can benefit.
- 2. Take out the items in the cage. First, rinse most of the dirt off the cage with water, and then wipe the dirt around it with a wet towel; And then clean the cage.
During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
- The cage can be placed in a corner so that the bird can see what is going on around it and can retreat to the back of the cage without fear of being approached. The height of the cage from the ground is also important and is ideal slightly below eye level.
Post time: 30-12-22After the corrosion of impregnated hexagonal wire mesh, the original characteristics will be lost, and the shape, color and mechanical properties will be changed, resulting in equipment damage, pipeline leakage, etc., specifically, it is easy to break and lose the original protection function. Usually, there are three kinds of metal corrosion: physical corrosion, chemical corrosion, electrochemical corrosion, corrosion in addition to the chemical properties and organizational structure of the metal itself, but also related to the surrounding medium, such as wet environment is easier to rust than dry environment, more impurities than impurities less easy corrosion, high temperature conditions than low temperature conditions easy corrosion. After understanding these, we can effectively prevent the corrosion of impregnated six-sided wire mesh, prolong the service life of the product.
- Suitable for general engineering building wall, pouring concrete, multi-storey building, etc., in the structure of heat preservation and heat insulation system plays an important role, when the construction will be hot dip galvanized welded wire rack together wall of heat preservation and heat insulation board placement will be concrete pouring mold inside, outside the wall heat preservation and heat insulation board and one kind of live, after ripping into heat preservation and heat insulation board and wall body. The coating on the surface of the welding core is called the coating.
The material of the blade can be roughly divided into high quality steel wire, galvanized steel plate, stainless steel plate. The general technology used on the blade: hot dip galvanizing – stamping. The blade has the advantages of corrosion resistance, aging resistance, good weather resistance, easy installation, low price and so on. The use of blade rope: Blade rope has been widely used in military sites, prisons, government, banks, residences, private homes, villas, doors and Windows, roads, railway fences and border lines, etc., to ensure safety. Most prisons basically use razor blades.
The corrosion or discoloration of galvanized iron wire in the atmosphere caused by oxygen, moisture and other pollution impurities is called rust or rust. After galvanized iron wire rusting, it will affect the appearance quality, seriously affect the use, and even cause scrap, so galvanized iron wire must be properly kept and pay attention to rust prevention.
Post time: 15-11-22- 2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.
Stainless STEEL HAS THE ABILITY to resist ATMOSPHERIC OXIDATION – that is, rust resistance, but also has the ability to resist corrosion in the medium containing acid, alkali, salt – corrosion resistance. However, the corrosion resistance of the steel varies with its chemical composition, additive state, service conditions and environmental media type.
The main difference between the two is the carbon content. The carbon content of iron is 2.11 percent or greater, while the carbon content of steel is 2.11 percent or less. The iron carbon alloy with carbon content above 2.11% is cast iron (pig iron), which is basically not malleable and cannot be drawn into wire. Secondly, the content of impurities is different. The content of harmful impurities such as sulfur and phosphorus in steel is smaller. Steel wire general color focus, iron wire color light point, white point.
Galvanized wire drawing is more common in our life, galvanized wire drawing refers to the production of galvanized iron wire after a series of processes such as shell stripping. The production process of galvanized wire drawing is more complex, and a series of problems may occur if there is a slight mistake. When the wire factory is engaged in the production of galvanized wire drawing, it is necessary to remove all the tools and piles that hinder activities on the work site and equipment.
- The diameter of welded mesh wire for external walls is generally 2.2-ф4.0, and the mesh is generally 25-50.
- Two, galvanized to prolong the service life of stainless steel barbed rope
Post time: 13-09-22The characteristics of these cages are small, light, easy to carry and easy to clean. For small animal cage, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violence”, otherwise the cage in the “destruction” will occur under the welding or plastic crack.
- 4, according to the wire diameter thickness to adjust zinc dipping time
After proper heat treatment or cold drawing hardening, high carbon steel wire has high strength and hardness, high elastic limit and fatigue limit (especially notched fatigue limit), cutting function is acceptable, but welding function and cold plastic deformation ability is poor.
- 6. Find a warm place until its fur is completely dry.
- Origin: Hebei
Pet cage has many types, and selective is bigger, pet cages are generally made of wire, with better coarse, then at the bottom with a wheel base, such a simple pet basket was made, in the wheel at the bottom of the mount is for the convenience of the mobile, a pet cages should also adapt to the location of the production in addition to a door, It is convenient for feeding pets.
Post time: 26-09-22Excellent anticorrosive makes its popularity in the feed, the net surface smooth and tidy, increased the look and feel, can be adornment effect, this characteristic makes it to show in the mining industry, due to high quality with low carbon materials as raw materials, to make it unique general iron mesh screen does not have flexibility, determine its plasticity in use process, Thus can be used in the hardware process of deep processing and manufacturing, complex wall batch swing, underground leakage prevention cracking, light mesh body, so that the cost is much lower than the cost of iron screen, more able to understand its economic and practical.
- (2) Greenhouse special electric galvanized shaft wire shall not be used for waist hoop compression reinforcement, usually not used for all binding.
Fence use: generally used as a fence is a plastic-impregnated welded wire mesh with a height of 1.2 meters to 2 meters. Most of the mesh holes are 6cm, and the wire diameter varies from 2mm to 3mm.
Post time: 10-04-23Hexagonal guardrail network custom corrosion lost the original characteristics, in the shape, color and mechanical properties will change, resulting in equipment damage, pipeline leakage, etc., specifically, it is easy to break, lose the original protection function.
- The common specifications of small hexagonal net in production are: the width is 1.22m, and the commonly used width is generally 1m. In terms of length, the small hexagonal net basically has no limitation. 1-100 meters can be produced. The production diameter of small hexagonal mesh is generally No. 27 wire to No. 18 wire, and the aperture size is 0.95cm-5.08cm.
- D, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.
- 2.0*2.0mm means that the two strands are 2.0mm silk, and the spines wrapped around the strands are also 2.0mm silk;
- Second, positive and negative twisting rope cost-effective
- After the wire mesh appears black spots, you can choose the appearance of treatment to deal with this problem, such as galvanized, paint, dip plastic to deal with, after the appearance of the welding mesh surface smooth and bright, beautiful and generous.
- Smelting technology is good, advanced equipment, advanced process of large stainless steel plant whether in the control of alloy elements, impurities removal, billet cooling temperature control can be guaranteed, so the product quality is stable and reliable, good internal quality, not easy to rust. On the contrary, some small steel equipment is backward, backward process, smelting process, impurities can not be removed, the production of products will inevitably rust.