1 3 4 galvanized ring shank nails

Greenhouse special electroplating process iron wire blackening solution:

For the specification of galvanized wire, the galvanized wire produced by our factory can range from No.8 to No.22, which refers to the BWG standard, that is, from about 4mm to 0.7mm, which can basically cover the type required by customers. As for the raw material of galvanized wire, normally, we use Q195 mild steel, and some factories will also use SAE1006 or SAE1008. The following is the zinc coating, for galvanized wire, this thing is more important, the general zinc coating is about 50g/m2 to 80g/m2, some customers need high zinc galvanized wire, zinc coating can reach 200g/m2 to 360g/m2. The tensile strength of galvanized wire is usually 350n/m2 to 800n/m2. Then there is the packaging specification of galvanized wire. The specifications of small rolls of galvanized wire are 50kg/ roll, 100kg/ roll and 200kg/ roll. Of course, there are large rolls of galvanized silk, the weight can reach 300kg/ roll or 800kg/ roll.

The drawing process of the product drawing process has a great influence on the product function. Generally, a large total surface reduction rate of about 90% (see area reduction rate) and a small pass surface reduction rate (about less than 23%) are selected to ensure the endurance of the product. On the high strength spring steel wire, drawing should control the exit temperature of each passage of the steel wire is lower than 150℃, to avoid the steel wire due to strain aging and appear to change the crack, which is the formation of steel wire scrap the primary disadvantage.

1. Cleaning: Soak the pre-treated steel wire in detergent to remove surface impurities and dirt.