3 16 perforated steel sheet

Latest articles

3 16 perforated steel sheet

...

3 16 perforated steel sheet 3 16 perforated steel sheet

Read More
  • The strength of the hook mesh should be satisfied: when the vehicle is traveling at 80 kilometers per hour, the hook mesh will not fall into the river when it bumps against the rail at a 15 degree Angle. The shape and color of the hook mesh should be in harmony with the surrounding natural environment. The phenomenon planning of the important Bridges of the hook network should be done well. When the bridge crosses important traffic lines, such as expressways, urban rail transit, expressways, railway trunk lines, etc., the hook mesh should add the protective mesh on the pavement of the bridge deck.

    3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More

  • Post time: 23-12-22

    3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • Hot dip galvanizing, also known as hot dip galvanizing, is a method of obtaining a metal covering layer by immersing a steel member into a molten zinc solution. With the rapid development of high-voltage power transmission, transportation and communication, the protection requirements for steel parts are becoming higher and higher, and the demand for hot-dip galvanizing is also increasing. Usually the thickness of electrogalvanized layer is 5 ~ 15μm, and the large roll galvanized wire layer is generally more than 35μm, or even up to 200μm. Hot dip galvanized coating ability is good, dense coating, no organic inclusions.

    3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.

    3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • 3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • welding

    3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • Wire factory introduction annealing wire is widely used mainly because it has good elasticity and flexibility, in the process of annealing can be very good control of its soft and hard degree, it is mainly made of iron wire, more often used in the construction industry tied wire use. In the production of annealing wire will be processed according to the performance of the material, according to the demand for different degree of hardness of its soft change, can make it has more advantages, can reduce the consumption of metal, reduce the cost of production.

    3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • 3 16 perforated steel sheet

    ...

    3 16 perforated steel sheet 3 16 perforated steel sheet

    Read More
  • 

    Popular articles

    Latest articles

    Links