stainless steel crimped wire mesh

Galvanized wire is immersed in heated molten zinc, the production speed is fast, the coating is thick but uneven. The thickness of 45 microns allowed by the market, the color is dark, the consumption of zinc metal is more, and the matrix metal is formed into an infiltration layer, and the corrosion resistance is good. The hot dip galvanizing can be maintained for decades in the outdoor environment.

As for the protection operation of galvanized barbed rope column, replace the column which is corroded or misinterpreted and so on, and place the replacement area from the beginning, and reinforce the column with unstable pile foundation in time. There is also about the protection of galvanized barbed rope itself, to repair the damaged local, will be severely replaced by rust.

The whole welding process of galvanized steel wire mesh does not need special technological methods, good weldability. However, in a few cases, the welding process will present difficulties: the converter steel produced by the old smelting method has high nitrogen content and high impurity content, resulting in high cold brittleness, added aging sensitivity, lower quality of welded joints, and poor weldability.

Pressure lock steel grid plate is at each intersection of bearing flat steel and horizontal bar, the horizontal bar is pressed into bearing flat steel or pre-slotted bearing flat steel through the pressure, the fixed steel grid plate, called pressure lock steel grid plate. The cross bar of the pressure lock steel grid plate is usually flat steel.

And high-quality data are constrained by production costs and production conditions, so some electric welding mesh manufacturers do not meet this requirement, in this case, there is no way to improve product strength. In addition to data, and produce process, even if again good data, but the factory did not meet the requirements of production process in welding, also can form the product under the high pressure welding, so it is also a kind of strength on the decline, process conditions of different manufacturers also have very big difference, so it formed a shopping mall on the above products are differences of strength.

The applications in which it can be used are paints, inks, plastics, elastomers, paper, fillers, adhesives…