galvanised stay wire

galvanised stay wire

...

galvanised stay wire galvanised stay wire

Read More
  • Galvanizing can be done by zincate galvanizing or chloride galvanizing. Appropriate additives shall be used to obtain a coating that meets the requirements of this standard. Luminescence treatment should be carried out after luminescence plating. The parts that need to be dehydrogenated for passivation should be passivated after dehydrogenation. Before passivation, 1%H2SO4 or 1% hydrochloric acid should be applied to activate 5~15s. Passivation shall be treated with colored chromate unless otherwise specified in the design drawings.

    galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More
  • In the calculation process of 12*14 specifications of barbed rope, it can not be calculated according to the above calculation formula, because first of all, two specifications of raw materials are used, the thinner the wire diameter, the higher the processing cost. Generally speaking, a kilogram of 12*14 barbed rope can reach about 7.5 meters, and the ratio of warp wire to barbed rope cannot be calculated according to the traditional ratio of 7 to 3. The specific use of how much wire and silk need to go through a series of professional measurement but also increase the loss of raw materials and other factors to calculate. Thorn rope factory will also according to customer needs to calculate the reasonable amount of customer use.

    galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More
  • The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.

    galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More
  • 1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.

    galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More
  • galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More

  • Post time: 23-02-23

    galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More
  • galvanised stay wire

    ...

    galvanised stay wire galvanised stay wire

    Read More
  • 

    Popular articles

    Latest articles

    Links