2d common nails

For key and important parts with tensile strength greater than 1034Mpa, the stress should be removed at 200±10℃ for more than 1 hour before plating, and for carburized or surface hardened parts, the stress should be removed at 140±10℃ for more than 5 hours. The cleaning agent used for cleaning shall have no effect on the binding force of the coating and no corrosion on the substrate. Acid activation Acid activation solution should be able to remove corrosion products and oxide film (skin) on the surface of parts without excessive corrosion on the matrix.

The coating of electrode plays a very important role in the welding process. If adopting the light of the coated electrode welding, is in the process of welding, oxygen and nitrogen in the air can invade the molten metal, the metal iron and beneficial elements carbon, silicon, manganese oxide and nitride oxide and nitride formation, and remain in the weld, weld slag or crack. And melt into the molten pool in the gas can make the weld produces a large number of pores, these factors can make the mechanical properties of the weld is greatly reduced, at the same time to make the weld brittle.

In order to remove defects such as surface film layer and surface inclusion of large roll galvanized wire, it can be treated by conventional technology. The presence of small homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles can cause explosion. Activated carbon mat to remove surface active substances, or through filtration to make the foam less stable, these are effective measures; Other measures should also be taken to minimize the intake of surface active substances. The electroplating speed can be significantly reduced by the introduction of organic matter.