soft annealed iron wire

The advantage of galvanized iron wire after annealing: after annealing increases the elongation of the iron wire. Makes the product softer and increases the range of application. After electric galvanizing hot dip galvanizing. Copper electroplating is widely used and screen production. Galvanized iron wire is a soft iron wire product processed by low carbon steel wire through cold drawing, heating, constant temperature, and even heat preservation. Generally, the quality of ordinary galvanized iron wire will be relatively soft, the softness is relatively balanced, and the color is consistent. It is mainly used in construction, mining, chemical industry and so on.

Wire diameter: 6#–20#, this kind of wire mesh is braided by low carbon steel wire; Aperture: 15′-15′ extra standard can be customized according to customer requirements. Usage: To be used for road beautification with protective net, maintenance and support of seawall, hillside, dam, etc., is a good data to avoid landslides.

Plastic spraying is also known as electrostatic powder spraying. It is the use of electrostatic attack device to make plastic powder charged, adsorbed on the surface of the iron plate, and then through the baking of 180~220℃, so that the powder can be melted and adhered to the metal surface. Plastic spraying products are mostly used in the indoor box, and the paint film appears flat or matte. Spray powder mainly acrylic powder, polyester powder and so on.

The difference is that hot dip galvanizing is dipped in zinc solution melted by heating, which has fast production speed and thick but uneven coating. The color is dark, the consumption of zinc metal is much, the formation of infiltration layer with the matrix metal, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can be maintained for decades. Cold galvanized is in the plating tank through the current unidirectional zinc gradually plated on the metal surface, the production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust.

During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.