Wire flexibility and elongation is good, can withstand the pressure of mechanical operation, in our country’s industry has played a very important role. There are many kinds of iron wire, the most common is to give black iron wire, galvanized iron wire. The corrosion resistance of the outer coating is effectively improved, but the phenomenon of crevice corrosion will be found after long-term use.
Crevice corrosion is a kind of corrosion in small area, especially in concealed position, which can form vicious corrosion cycle. Almost all the crevice corrosion can occur in a metal alloy, with gas containing active anionic neutral medium Z is easy to cause crevice corrosion, crevice corrosion often occurs in the aperture of 0.025 to 0.1 mm, because of long time gathered, the cracks will exist a series of impurities, coupled with the external environment of damp easily corrode the area of the gap is small.
Long-term exposure to such impurities will result in transition and gap corrosion. The direct solution to this phenomenon is to strengthen the coating of the material to avoid corrosion. Improve the quality of galvanized iron wire, can use the wire that had plated zinc beforehand to pull out when making galvanized iron wire, won’t appear the phenomenon of bad mechanical properties. The toughness of the wire is 15 to 25 per cent higher than that of the drawn and galvanized wire, and in some cases slightly stronger than that of the polished wire.
The wire after the first plating, its strength limit is also higher than the first plating, plated zinc and then made of wire not only toughness and high strength. There is a lower figure in the strength limit of galvanized iron wire because of the quality of zinc, because the strength of zinc technology is several times smaller than the wire itself. It is difficult to hot-dip galvanize drawn wires, and it is impossible for finer and very fine wires to be coated with the desired thickness of smooth zinc.
Post time: 17-05-22
