The application method of hot plating wire: the pull direction of the goods should be reasonably selected. To avoid horizontal movement of goods, the pull direction should be as low as possible. Used to avoid goods overturning, pull azimuth can be appropriately higher. The use of galvanized iron wire, pull reinforcement methods are mainly: figure eight, figure eight, cross, and shape or shape and so on. All kinds of pulling methods can be used alone, or two or more kinds of combination. Tension may be symmetric.
When pulling and strengthening, the single or double strand galvanized iron wire is reciprocated between the two tied knots of goods and vehicles, and the galvanized iron wire should be pulled tight to make the tightness of each strand common, and some of the rest are crossed around their own rope rod, and the use of the cutter is tightened, and the rest of the tail is toward the car. Do not damage galvanized iron wire when twisted tightly. Stop using more than two strands of galvanized iron wire around the operation method. The diameter of galvanized iron wire for pulling shall not be less than 4mm, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm.
Galvanized iron wire shall not be used for lower pressure reinforcement of waist bands and is usually not used for integral binding. Warehouse galvanized wire used to block and distinguish regional function, warehouse galvanized wire is one of the first use of galvanized wire, warehouse galvanized wire first layout features are as follows: layout mode: Column + net frame, column to choose square steel pipe, galvanized wire frame also to small square pipe for data, column and net frame corresponding azimuth are welded joint lug (flat iron), column and net frame through the bolt on the joint lug fixed, column bottom welding bottom plate, column bottom plate is fixed with the expansion bolt and the ground.
Post time: 24-08-21
